Configuring Service VPN1, Interface & OSPF Templates for vEdges

This SD-WAN lab practical will show you how to configure Feature Templates for OSPF for VPN0. You can practice along with this practical using our SD-WAN virtual lab.

Topology 

Tasks 

1. Configure a Service VPN Template with the following parameters for Branch vEdge cloud devices 

● Template Name: BR-VE-VPN-VPN1 

● Description: BR-VE-VPN-VPN1-Description 

● Basic Information  

✓ VPN -> Global: 1  

✓ Name -> Global: Data VPN 

2. Configure VPN1 Interface Template with the following parameters to be used by all Branch vEdge cloud devices for Interface G0/2 

● Template Name: BR-VE-VPNINT-VPN1-G2 

● Description: BR-VE-VPNINT-VPN1-G2-Description 

● Basic Configuration  

✓ Shutdown-> Global: No  

✓ Interface Name-> Global: Ge0/2 

✓ IPv4 Address-> Static-> Device Specific  

3. Configure OSPF Template with the following parameters to be used by all Branch vEdge cloud devices for VPN1 

● Template Name: BR-VE-OSPF-VPN1 

● Description: BR-VE-OSPF-VPN1-Description 

● Area Configuration  

Area Number ➔ Global: 0  

✓ Area Type ➔ Default  

Interface Configuration-> Interface Name: Ge0/2 

● Redistribution  

✓ Protocol: OMP 

Online Cisco SD-WAN TrainingLearn from expert trainers and master SD-WAN.Explore course

Configuration and Verification 

To create service VPN template, go to vManage and navigate to configuration-> Templates-> Feature and click on Add Template.

On the left plane scroll down and select vEdge Cloud under select Devices and then on right plane select VPN to configure the Service VPN1 template 

Here fill the values of template name, description, and other values as per required in the tasks and leave all other values as default. Click on Save to continue 

VPN1 template has been created and can be seen here with other templates 

Now create service VPN interface template, go to vManage and navigate to configuration-> Templates-> Feature and click on Add Template 

On the left plane scroll down and select vEdge Cloud under select Devices and then on right plane select VPN Interface Ethernet under VPN to configure the Service VPN1 interface template 

Here fill the values of template name, description, and other values as per required in the tasks and leave all other values as default.  

Scroll down under basic configuration, select Static and IP address as device specific and click save to continue 

Service VPN1 interface template has not been created and can be seen along with other templates 

Now create OSPF template for VPN1 to be used by vEdge Cloud devices, on vManage, navigate to configuration-> Templates-> Feature and click on Add Template 

On the left plane scroll down and select vEdge Cloud under select Devices and then on right plane scroll down and select OSPF under other templates to configure the OSPF for Service VPN1  

Fill the values of OSPF template name and description as per task requirement 

Go to redistribution section and click on New Redistribution  

Here you can choose protocol as OMP to redistribute OMP into OSPF and click on Add to continue 

Go to Area section and click on New Area  

Enter OSPF area 0 and area type is default. Click on Add Interface  

Provide the value Ge0/2 for interface and click on Add to continue 

Interface Ge0/2 is added in OSPF area configuration and be below now click on Add again to continue 

Click on Save to continue  

Here you can see that OSPF template is created for VPN1